Whether you cutoff to interchange a tire and asset that the rotate nuts aren't tight, you obligation latest studs. It's not that crucial to exchange the revolve stud on your Acura Integra. You charge a inappreciable accomplishments approximately the brakes to disassemble the shove and a petty manpower to remove the to discharge the profession.
Instructions
1. Obtain a advanced stud to interchange the stud in your Acura Integra. You need the proper size, if you don't know it, wait until you remove the stud and take it to the auto parts store with you.
2. Locate the jack and tools. The tools are in the spare tire well under the floor mat and the jack butts up between the end of the trunk and the tire. You need to turn the jack bracket counterclockwise to remove it. Put blocks on the wheel diagonal to the point that you place the jack.
3. Jack up the vehicle and remove the wheel. You then need to remove the calipers and discs for disc brakes. If the rear is a drum brake, simply remove the brake drum. See if you can remove the stud without removing the hub. You may need to take off the hub and put it in a vise. If you do, skip to step 5.
4. Look for a cut out opening behind the hub Line the stud up with the opening so you have space to both remove and replace the stud
5. Hit the stud with a mallet to drive it back through the hub's hole. Replace the stud with your new one. Seat it. You check this in the back. When the head of the stud is flush with the back of the hub, you have seated the stud.7.
Insert the stud as far as you can into the hole.6. Tighten down the stud by placing two wheel bolts on the front and tightening them. This draws the stud through the hole as you tighten it.
Put the wheel assembly back on in the order that you removed it to replace the stud on your Acura Integra. Tighten the wheel nuts down
