You may extremity to modify the adequate brake caliper whether your brakes are pathetic.
Chrysler manufacturers the Town & Sovereign state with an anti-locking brake action, four-wheel CD brakes, all-season tires and 16-inch wheels. In the vehicle, the CD brake connects to a metal CD that turns alongside the wheels. The brake caliper slows the hurry of the wheels by producing friction with the metal CD. Provided you devoir to alternate the brake caliper due to damage, you can save almighty dollar by changing the tool yourself.
Instructions
Overhaul, Replace or Reseal the Brake Caliper
1.6. Sanitize the surface of the steering knuckle abutment. The unit may contain dust, dirt, rust or oil.
Detach the mounting bolt from the brake caliper to revenue off the brake hose. Lob gone the broken down washer. Seal the brake hose to enjoy the brake fluid from spilling.
3. Revenue the brake caliper design pin bolts from the brake caliper to detach it from the steering knuckle.
4. Glide the brake caliper from the steering knuckle. Glide the other end of the caliper out from underneath the machines abutment attached to the steering knuckle.
5. Hold the brake caliper assembly from the strut component with wire. Do not allow the brake caliper to dangle from the hose to prevent damaging the brake hose.
Lift the front of the Chrysler with floor jacks. Bed the vehicle with jack stands.2. Grease the surface with Mopar Multipurpose Lubricant or a comparable solution
7. Place the brake caliper on top of the brake pads and rotor. Place the guide pin bolts back into the brake caliper and use a torque wrench to torque the bolts to 16.25 foot-pounds for the front caliper and 16 foot-pounds for the back calipers.
8. Connect the brake hose to the brake caliper with new washers. Use the torque wrench to torque the banjo bolts to 35 foot-pounds.
9. Bleed the system.
10. Place the front wheel back on the vehicle and position the lug nut in a star pattern and torque to half the torque specifications: 50 foot-pounds. Do the entire cycle again to the full torque of 100 foot-pounds.
11. Place the vehicle on the ground to a level surface. Push the brake pedal numerous times to verify a firm brake pedal. Test the vehicle on the road after the brake pedal is firmly set.
