Exchange Rear Struts
Lift the automobile with a jack and abode jack stands under the rear frame of the vehicle to assist it while you assignment.2. Remove the rear tire on one side of the motorcar with a lug wrench to loosen the lug nuts. It may share some generation to perform the daily grind, on the other hand the method is relatively mild.
Instructions
1.Struts absorb the movement of your vehicle as you handle over uneven way surfaces, forming your drive smoother. When struts shift worn, they Testament not dampen the movement, and the propel becomes bouncy and Rugged. Yet whether decent one strut is worn, they longing to be replaced in pairs. There is no allot lifetime to modify this type of effects; it is done when the component is no longer doing an compelling task of supporting the van.
Remove the nuts, pull the tire off and locate them aside.
3. Establish the strut mount assembly and spray the nuts with lubricant. These areas Testament possible be rusted and begrime; the lubricant Testament lift loosen any debris locking them in put.
4. Remove the backside nuts from the knuckle assembly then remove the top three nuts from the strut mount assembly. Remove the strut from the car carefully.
5. Mount a spring compressor tool and collapse the spring on the strut. Mark the spring so you know which end is the top. Remove the spring nut and remove the strut from the spring. Do not remove the spring compressor tool from the spring; keep it collapsed until it is remounted on the new strut.
6. Position the spring on the new strut with the compression tool in place. Reassemble the mount and replace the retaining nut. Make sure the spring is in the seat correctly and, when everything is in place, begin to loosen the spring compression until it is fully extended on the new strut.
7. Maneuver the new strut into place and reinstall the bottom bolts. Reinstall the upper mounting nuts and tighten them into place. You may need to use the jack to lift or adjust the suspension slightly to do this as the new strut is not worn and may be slightly longer than the one you removed. Be sure everything is secured and in place, then remount the wheel on the car.
8. Repeat the steps as above for the other side.
