The 1991 Toyota four-wheel impel pickup has a starter Engine on the passenger side of the engine. Replacing the starter Engine on the Toyota four-wheel ride Motor lorry may grow into cold provided your starter starts grinding or dragging. Since the starter motor is so low on the engine, it can be affected by flood and out elements such as mud or way debris. A replacement starter Engine for your Toyota is available from Toyota or any Car parts store.
Instructions
1. Frank the hood of your Toyota pickup and fix the bad battery cable on the battery. Remove the retaining bolt from the cable borderline with a wrench and remove the cable from the battery. Isolate it from the battery while you business on the electrical cables of the starting course.
This is the "B" terminal. Loosen the retaining fan with a socket and ratchet then remove the cable from the starter. The moment is the "S" terminal and it has a smaller wire with a push in style connector on the foot.
Fix the starter motor from under the passenger side of the engine compartment. There are two electrical connections on the starter to deal with. The fundamental is a excessive unmarried wire that attaches to the starter by sliding onto a stud type terminal.2. Uplift the front stop of the Motor lorry with a jack and cooperate the Motor lorry on a establish of jack stands. Some four-wheel guide models are alpine Sufficiently that you may be able to assignment under it without the jack.3. Proceeds the locking tab by squeezing it and pull the connector absent.
4. Fix the two mounting bolts at the front of the starter and remove them from the back transmission side of the ring housing using a socket and ratchet. Remove the elderly starter from the Motor lorry and discard it. Install the advanced starter in the Motor lorry by placing the nose cone of the starter into the gap in the call housing.
5. Install the two mounting bolts into the starter and tighten them with a socket and ratchet. Connect the two wiring harness connectors to the terminals on the starter, pushing the wire to the "S" terminal in first. Connect the second wire to the "B" terminal followed by the retaining nut, then tighten the nut with a socket and ratchet.
6. Lift the truck off the jack stands with a jack, remove the stands from under the truck and lower the jack, setting the truck back on the ground. Connect the negative battery cable end to the negative battery terminal. Install the retaining bolt for the negative battery cable and tighten it with a wrench.
7. Close the hood on your Toyota truck. Test the repair by starting the truck to ensure the starter works correctly.
